Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
12.1. Safety locks
12.2. The burned-through crossing points
12.3. Automatic switches
12.4. Relay
12.5. Breakers of indexes of turns / alarm system
12.6. The combined switch
12.7. The switches installed on a steering column
12.8. Lock of ignition and drum of the lock
12.9. Switch of a heater of back glass
12:10. Heater of back glass
12:11. Radio receiver and loudspeakers
12:12. Antenna
12:13. Bulbs of headlights of head light
12:14. Headlights of head light
12:15. Replacement of bulbs
12:16. System of day inclusion of headlights
12:17. Engine of screen wipers
12:18. Instrument guard
12:19. Sound signal
12:20. System cruise control
12:21. System of the central lock
12:22. System of window regulators
12:23. Rear-view mirrors with the electric drive
12:24. Safety airbag
+ 12:25. Electrical circuitries
|
Prevention
On these models the safety airbag is installed. The airbag of safety can reveal (to be filled with air) at any time when it is connected to the accumulator. In order that it incidentally did not reveal (and did not put a trauma), turn a key in the ignition lock in position of LOCK and disconnect a wire of the negative plug of the accumulator before work with a safety cushion. After an accumulator detachment, wait at least two minutes before work (the module of a safety cushion has the condenser block which has to be discharged completely). For more information see subsection 12.24.
If the stereoplayer of your car has system of the coding, check whether you know a code of activation of the player before an accumulator detachment.
Check
| PERFORMANCE ORDER |
| 1. The breaker of indexes of turns / the alarm system, the small rectangular element located on the central block of safety locks serves for faltering work of bulbs of indexes of turns. |
| 2. When the breaker works normally, you have to hear rather loud clicks during its work. If indexes of turns do not work at one of the parties of the car and the breaker does not publish characteristic clicks, so one of bulbs fused |
| 3. If breakers of turns do not work at both parties of the car, so obviously, the safety lock fused, the breaker failed, the switch is broken or in a chain somewhere there is a bad connection. If when checking the block of safety locks, you find out that the safety lock of indexes of turns fused, check an electric chain for existence of short circuit before installation of a new safety lock. |
|
Replacement
| PERFORMANCE ORDER |
| 1. For replacement of the breaker, just get it from the block of safety locks. |
| 2. Check that the new breaker was just the same model and type, as well as old. Compare them among themselves before installation of the new breaker. |
| 3. Installation is carried out upside-down removals. |
|
|
|
