Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
   12.1. Safety locks
   12.2. The burned-through crossing points
   12.3. Automatic switches
   12.4. Relay
   12.5. Breakers of indexes of turns / alarm system
   12.6. The combined switch
   12.7. The switches installed on a steering column
   12.8. Lock of ignition and drum of the lock
   12.9. Switch of a heater of back glass
   12:10. Heater of back glass
   12:11. Radio receiver and loudspeakers
   12:12. Antenna
   12:13. Bulbs of headlights of head light
   12:14. Headlights of head light
   12:15. Replacement of bulbs
   12:16. System of day inclusion of headlights
   12:17. Engine of screen wipers
   12:18. Instrument guard
   12:19. Sound signal
   12:20. System cruise control
   12:21. System of the central lock
   12:22. System of window regulators
   12:23. Rear-view mirrors with the electric drive
   12:24. Safety airbag
   + 12:25. Electrical circuitries

12:13. Bulbs of headlights of head light

GENERAL INFORMATION

Prevention

On these models the halogen bulbs filled with gas under pressure are established, and the bulb can burst if to scratch its surface or to drop a bulb. You wear goggles and handle bulbs accurately if perhaps, holding a bulb only for the basis. Do not touch a bulb surface by fingers as fat from your skin can lead to an overheat of a bulb and its premature exit out of operation. If you concerned a bulb surface, clear it by means of methyl alcohol.

If the stereoplayer of your car has system of the coding, check whether you know a code of activation of the player before an accumulator detachment.

Replacement

PERFORMANCE ORDER

1. Open a cowl.
2. Disconnect a wire of the negative plug of the accumulator.

3. If it is necessary, remove an air inlet for receiving access to a reverse side of the holder of a bulb.
	4. Press on a rychazhok and disconnect the connection socket from the holder of a bulb.
	5. Turn the holder of a bulb counterclockwise and remove him from the headlight panel (if to look behind). Trying not to touch bulb glass by naked fingers, establish a cartridge with a new bulb on a headlight and turn it clockwise shooters for fixing.
6. Connect the socket of connection and a wire of the negative plug of the accumulator. Check work of a headlight of head light, then close a cowl.

home