Toyota Corolla

1992-1998 of release

Repair and operation of the car

Arrangement of elements of the electric drive of glasses of a rear view

1. Block of safety locks N2 (ALT safety lock, AM1 safety lock) 2. External rear-view mirror

3. Ignition lock 4. Block of safety locks N1 (Safety lock of a lighter and radio receiver) 5. Regulator of provision of a mirror

Rear-view mirrors with the electric drive use two engines for change of provision of a mirror; one for adjustment in the vertical plane and one for adjustment in horizontal.

The regulator of provision of mirrors has the switch which allows to switch management of the left and right mirrors. When the key in the lock of ignition is turned in the provision of ASS, lower glasses and check operation of the regulator in all provisions (adjustment of mirrors up – down and to the right – to the left) for the left and right rear-view mirrors.

Table of connection of a tester and conductivity of the regulator of provision of a rear-view mirror

1. Adjustment of a mirror to the left-to the right

Check

PERFORMANCE ORDER

1. Listen to a sound of the electric motors changing the provision of mirrors. 2. If you hear engines, but mirrors do not move probably the drive in a mirror is faulty. Remove and sort a mirror for detection and elimination of a source of malfunction. 3. If a safety lock as it should be, remove a ventilating lattice / panel of the regulator from the dashboard for receiving access to the back party of the regulator of provision of mirrors, without disconnecting a wire. Include ignition and check presence of tension on the regulator. Tension has to be present only at one plug. 4. If on the regulator there is no tension, check wires between the block of safety locks and the regulator for existence of a gap or short circuit (see the tab. Table of connection of a tester and conductivity of the regulator of provision of a rear-view mirror). 5. If at the regulator there is tension, disconnect it. Check it for conductivity of current at all provisions of the regulator. If the regulator does not carry current, replace it. 6. Connect the regulator. Find the wire going from the regulator to the mass of the car. Without disconnecting the regulator, connect a cap wire between this wire and mass of the car. If after this mirror work, restore grounding of the switch. 7. If the mirror still does not work, remove it and check mirror wires for presence of tension. Check tension at the included ignition, and the regulator has to be switched for adjustment of this mirror. Switch the regulator through all provisions. On one of the wires connecting the switch and a mirror there has to be tension when the regulator is in any of provisions (except neutral situation off). 8. If at any of provisions of the regulator, tension on wires of a mirror is absent, check wires between a mirror and the regulator for existence of gaps or short circuit. 9. If tension is present, remove a mirror and check its work, having connected cap wires. Replace a mirror if it is faulty.