Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
- 12. Electric equipment
   12.1. Safety locks
   12.2. The burned-through crossing points
   12.3. Automatic switches
   12.4. Relay
   12.5. Breakers of indexes of turns / alarm system
   12.6. The combined switch
   12.7. The switches installed on a steering column
   12.8. Lock of ignition and drum of the lock
   12.9. Switch of a heater of back glass
   12:10. Heater of back glass
   12:11. Radio receiver and loudspeakers
   12:12. Antenna
   12:13. Bulbs of headlights of head light
   12:14. Headlights of head light
   12:15. Replacement of bulbs
   12:16. System of day inclusion of headlights
   12:17. Engine of screen wipers
   12:18. Instrument guard
   12:19. Sound signal
   12:20. System cruise control
   12:21. System of the central lock
   12:22. System of window regulators
   12:23. Rear-view mirrors with the electric drive
   12:24. Safety airbag
   + 12:25. Electrical circuitries

12.8. Lock of ignition and drum of the lock

GENERAL INFORMATION

Prevention

On these models the airbag of safety which can reveal (it will be filled with air) when it is connected to the accumulator is installed. Disconnect a wire of the negative plug of the accumulator and wait at least two minutes before work with the safety airbag.

If the stereoplayer of your car has system of the coding, check whether you know a code of activation of the player before an accumulator detachment.

IGNITION LOCK

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the negative plug of the accumulator.

2. Remove a steering wheel (see subsection 10.16).

3. Remove a casing of a steering column (see subsection 11.22) and the lower panel of finishing (subsection 11.23).

Table of connection of a tester and conductivity of the lock of ignition

Check and replacement

PERFORMANCE ORDER

1. Check wires from the ignition lock to the socket of connection and disconnect it.

2. By means of an ohmmeter check conductivity of electric current between the specified plugs when the key in the lock of ignition is turned in various provisions.

3. Replace the ignition lock if conductivity between contacts of the socket of connection not such as it is specified in the table.

4. Turn off the screws fixing the ignition lock to the case of a drum of the lock and remove the ignition lock.

5. Installation is carried out upside-down removals. Being guided by instructions, (see subsection 10.16) adjust the wire twirled by a spiral before installation of a steering wheel.

DRUM OF THE LOCK OF IGNITION

Check and replacement

PERFORMANCE ORDER

	1. When the key is in the provision of giving of food on car electric equipment (the provision of ASS), insert the small screw-driver or a spoke into a case opening, press on the disconnecting button and get a drum. Remove it from a steering column.
2. Installation is carried out upside-down removals. Being guided by instructions, (see subsection 10.16) adjust the wire twirled by a spiral before installation of a steering wheel.

home