Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   + 3.2. Diesel engine
   - 3.3. Engine electric equipment
      3.3.1. Specifications
      3.3.2. Battery
      3.3.3. Power cables
      3.3.4. System of ignition
      3.3.5. Ignition coil
      3.3.6. Ignition distributor
      3.3.7. Check and installation of the moment of ignition
      3.3.8. Block of electronic ignition
      3.3.9. Induction sensor
      3.3.10. System of a charge of the battery
      3.3.11. Generator
      3.3.12. Generator details
      3.3.13. System of launch of the engine
      3.3.14. Starter electric motor
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

3.3.13. System of launch of the engine

GENERAL INFORMATION

Details of a starter and traction relay

1. Forward cover of a starter
2. Obgonny coupling assembled
3. Steel ball
4. Spring
5. Traction relay assembled
6. Coupling bolt
7. Ring laying
8. Brush holder
9. Back cover

10. Ring laying
11. The starter case with excitement windings
12. Ring laying
13. Anchor
14. Back bearing
15. Forward bearing
16. Bearing
17. Intermediate gear wheel

The system is intended for launch of the engine due to rotation of a bent shaft with a necessary speed.

The system consists of the battery, a starter, the traction relay and connecting wires. The traction relay is mounted directly on a starter.

The starter assembled with the traction relay is mounted in the top part of the engine, near a case of transmission (check point).

At turn of the ignition key in situation Start the traction relay on which tension through an auxiliary chain of start-up moves works. The traction relay connects a starter to the battery. The battery supplies a starter with the electric power and the starter rotates a bent shaft, making mechanical work on start of the engine.

On the cars equipped with the manual transmission, the starter can join only at the pressed coupling pedal. On cars with automatic transmission the starter can join only in that case when the lever of the selector is in situation Park or Neutral.

Prevention

At repair of units of system of start of the engine observe the following precautionary measures:
      – inclusion of a starter is allowed for the period of no more than 15 seconds with the subsequent pause not less than 2 minutes (otherwise there is an overheat of a starter and its exit out of operation);
      – as the starter is directly connected to the battery, at inept actions, overloads or casual short circuits formation of an arch and emergence of the fire is possible;
      – before repair of units of system of start of the engine always disconnect the battery from weight.

home