Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines
   - 3.2. Diesel engine
      3.2.1. Specifications
      3.2.2. Replacement of a gear belt
      3.2.3. Removal of a head of cylinders
      3.2.4. Dismantling of a head of cylinders
      3.2.5. Partition of a head of cylinders
      3.2.6. Assembly of a head of the block of cylinders
      3.2.7. Installation of a head of cylinders
      3.2.8. Check and adjustment of gaps of valves
      3.2.9. Check of a compression of cylinders
      3.2.10. Pistons and rods
      3.2.11. Measurement of cylinders
      3.2.12. Assembly of pistons and rods
      3.2.13. Installation of pistons and rods
      3.2.14. Bent shaft and flywheel
      + 3.2.15. Cooling system
      + 3.2.16. Lubrication system
      3.2.17. Device of injection of diesel fuel
      3.2.18. Operation of the car on diesel fuel
      3.2.19. Fuel filter
      3.2.20. Fuel pump of high pressure
      3.2.21. Nozzles
      3.2.22. Glow plugs
      3.2.23. Adjustment of the mode of idling
      3.2.24. Adjustment of the maximum turns
      + 3.2.25. Useful tips to owners of the diesel engine
   + 3.3. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

3.2.7. Installation of a head of cylinders

PERFORMANCE ORDER

1. Impose new laying of a head on the block of cylinders. Check that the forward party of laying coincides with the forward party of the engine. Both pins have to pass through laying.

2. Check that the pin on the end of the camshaft was from above and impose a head of cylinders on the block of cylinders so that pins entered.

3. Grease a carving and the lower parties of heads of bolts of a head of cylinders with engine oil and screw bolts in openings.

4. Wrap bolts of a head of cylinders in the sequence, return specified rice. An order of an inhaling of bolts of a head of cylinders, for three passes till the final moment of an inhaling of 84 N. of m.

5. Tighten laying of a cover of a head of cylinders and put on a cover (gaps of valves have to be already adjusted). The contact surface at the left and to the right of a camshaft flange from the forward party, and also in the middle at the left and to the right of the camshaft has to be covered with a sealant layer. The cover fastens six washers and nuts. Tighten nuts m 7 N.' moment.

6. Put an average cover of a gear belt and after that establish all removed details of the drive of the gas-distributing mechanism as it was already described.

7. Other works are performed upside-down. The following hoses have to be connected: a returnable fuel hose to the fuel pump, two water hoses to a head of cylinders, two fuel hoses to the fuel pump of high pressure.

home