|
|
1. To prevent the movement of the car lifted on a jack, block a wheel, diagonalno opposite to punctured. Enclose blocks in front of a forward wheel and behind back. |
|
|
2. Hook a cap a slanted part of a stripper of a cap.
On cars with the petrol engine as a stripper it is possible to use the handle of a candle key. |
Prevention
It is not allowed to take off a cap manually. At the address with a cap it is necessary to observe extra care to avoid injuries.
|
| |
3. Before raising of the car it is necessary to weaken an inhaling of nuts of wheels. For this purpose turn off a nut counterclockwise. For obtaining the maximum effort have a key so that the handle was from the right hundred-wound. At an otvorachivaniye be taken by the edge of a handle, you watch that the key did not slide off a nut. Nuts need to be weakened only half way, not to turn off completely. |
|
4. To establish a jack only under the places specified illustrations. The platform of installation of a jack has to be equal and firm. |
|
5. Make sure that in salon there are no passengers, and lift the car so that it was possible to establish a spare wheel. Remember that for installation of a spare wheel the car should be lifted above, than at removal of punctured. |
| 6. For rise insert the jack handle into an earring and rotate clockwise. At the very beginning of rise be once again convinced of correctness of installation of a jack. |
|
7. Turn off nuts and remove the punctured wheel. |
| 8. Drive a spare wheel and you will expose so that openings in a disk were opposite to hairpins. |
| 9. Lift a wheel and dress on the top hairpin. Having shaken, dress a wheel on other hairpins. |
|
10. Before establishing a wheel, remove corrosion traces on places of a prileganiye of a disk with a metal brush. The insufficient prileganiye of a disk can lead to an otvorachivaniye of nuts and a separation of a wheel when driving. Therefore through each 1600 km check an inhaling of nuts of wheels. |
| 11. Screw nuts of wheels (inside a conical part), tighten by hand. Wring out a wheel and at an opportunity tighten nuts. |
| 12. Lower the car and tighten nuts. For this purpose rotate the jack handle counterclockwise. For an inhaling of nuts use only a key for wheel nuts. Tighten nuts manually, use of the foreign means and tools changing the inhaling moment (the hammer, a pipe, etc., and also to hold out nuts, planting the feet against a key), is not allowed. |
|
|
|
| 13. Make sure that the key is reliably dressed on a nut. Wrap nuts gradually in the order specified illustrations. Repeating the sequence of an inhaling, finally tighten nuts. |
|
14. Establish a cap in the place and slightly kill with a leg before click. |
| 15. After change of a wheel check pressure in the tire of the established wheel. Adjust pressure according to the norms specified in part 8. |
| 16. If pressure is lower nominal, then at a small speed reach the next workshop and pump up the tire. Do not forget to wrap a gate cap, otherwise dirt can get to a zolotnik and cause to flow. In case of loss of a cap get as soon as possible and establish. |
| 17. Lay a jack, the damaged wheel and the tool on the places. As soon as possible tighten wheel nuts a dynamometer key with the set moment, repair the damaged tire. |
