Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
- 1. Maintenance instruction
   1.2. Codes of models
   1.3. Control panel
   + 1.4. Combination of devices
   + 1.5. Governing bodies and instrumentations
   - 1.6. Launch of the engine and driving
      1.6.1. Check before launch of the engine
      1.6.2. Check after launch of the engine
      1.6.3. Methods of driving
      + 1.6.4. Towage of the trailer
      1.6.5. Actions at refusal of launch of the engine
      1.6.6. Obligatory set of tools and spare wheel
      1.6.7. Replacement of a wheel
      1.6.8. Towage of the car
      1.6.9. Motor compartment
      1.6.10. Arrangement of safety locks
      1.6.11. Check of level of oil in the engine
      1.6.12. Choice of brand of oil
      1.6.13. Check of level of cooling liquid
      1.6.14. Composition of cooling liquid
      1.6.15. Check of pressure in tires
      1.6.16. Replacement of tires
      1.6.17. Shift of wheels
      1.6.18. Installation of winter tires and chains
      1.6.19. Precautionary measures for cast aluminum disks
      1.6.20. Check of an external condition of the battery
      1.6.21. Check of level of electrolyte
      1.6.22. Battery charging
      1.6.23. Check and replacement of safety locks
      + 1.6.24. Replacement of lamps
   1.7. Specifications
   1.8. Adjusting data, filling capacities and liquids
   + 1.9. Possible malfunctions
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



1.6.11. Check of level of oil in the engine

GENERAL INFORMATION

 
1. To add
2. Normal level
3. Transfusion
L. Lower mark
F. Top mark

Level of oil is checked on the heated-up engine.

PERFORMANCE ORDER
1. Install the car on the flat platform. Stop the engine and wait several minutes that oil flew down in the pallet.
2. Get the probe and wipe.
3. Insert the probe against the stop.
4. Get the probe and determine oil level by the provision of an oil film
5. If level is below the lower mark, then turn off a stopper and add oil of the same brand which is filled in in the engine. Add in the small portions, periodically checking level. The oils given about the approximate quantity necessary for finishing level from the lower mark to top, are given in the table.
6. After a dolivaniye densely wrap a stopper.
7. Transfusion is not allowed, otherwise the engine fails.

For engines 2E, 4E-FE and 7A-FE
1,2
For engines 4A-FE and 2S
1,0