Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Fan and relay of turning on of the fan
4.5. Radiator and broad tank
4.6. Pump of cooling liquid
4.7. Sensor of temperature of cooling liquid
4.8. Fan block
4.9. Heater radiator
+ 4.10. Control panel of a heater and conditioner
4.11. Vlagootodelitel of the conditioner
4.12. Compressor
4.13. Condenser
4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Depressurize the conditioner and remove coolant in service of Toyota car service or in a specialized workshop. |
| 2. Remove a radiator (see subsection 4.9). |
|
3. Remove a decorative lattice (see subsection 11.26) and a right headlight (see subsection 12.14). Disconnect the union of tubes of a supply and removal of coolant. To disconnect the right tube, turn off a flange bolt (it is specified by an arrow). Muffle the disconnected tubes to prevent moisture hit. |
Prevention
The left joint is connected to a receiver (see subsection 4.11).
|
|
4. Turn off two bolts of fastening of the condenser – on one from each party (the right bolt is shown). Displace the condenser back and remove from the car. |
|
Installation
| PERFORMANCE ORDER |
| 1. Install the condenser and arms, wrap bolts. Be convinced of reliability of fastening of rubber pillows on the condenser. |
| 2. Attach coolant tubes, replace ring laying. If the new condenser is installed, then enter 4–6 g of fresh oil of the recommended brand. |
| 3. Other details are established upside-down. |
| 4. Fill the conditioner with coolant in the same workshop in which depressurization and removal of coolant were carried out. |
|
|
|
