Toyota Corolla

1992-1998 of release

Repair and operation of the car


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
   4.1. Specifications
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Fan and relay of turning on of the fan
   4.5. Radiator and broad tank
   4.6. Pump of cooling liquid
   4.7. Sensor of temperature of cooling liquid
   4.8. Fan block
   4.9. Heater radiator
   - 4.10. Control panel of a heater and conditioner
      4.10.1. Air conditioning system
   4.11. Vlagootodelitel of the conditioner
   4.12. Compressor
   4.13. Condenser
   4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



bbeb4949

4.10. Control panel of a heater and conditioner
GENERAL INFORMATION

Scheme of check of short circuit of contacts of the switch of speed of rotation of the fan
The switch is in situation "Low" – contacts 3 and 7 are closed
In situation "M1" – contacts 3, 7 and 8 are closed
 In situation "Sq.m" – contacts 3, 6 and 7 are closed
In the provision of "HI" – contacts 3, 7 and 8 are closed

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Remove decorative overlays of average control panels (see subsection 11.21).
3. Get heads of regulators.
4. Unscrew fastening screws from the control panel face. Disconnect sockets.
5. Give the panel on yourself a little. Turn tags (it is specified by an arrow) in places of fastening of covers of cables of management. Remove cables from the control panel. Disconnect sockets.
6. Installation is carried out upside-down.
7. Start the engine, check existence of leaks and work of systems of heating and conditioning (if is available).

Adjustment of a cable of management

PERFORMANCE ORDER
1. After fixing of cables on the control panel and after installation of the control panel it is necessary to adjust tension of cables. Transfer handles of management to provisions RECIRC, COOL and DEF.
2. For adjustment of a cable of control of the gate of an air inlet transfer a control lever the gate to situation RECIRC (2). Fix an earring of a cable and a collar (1) of a cover of a cable in the place.
3. For adjustment of a cable of control of the gate of the regulator of air temperature transfer the gate to position of COOL (2). Fix an earring of a cable and a collar (1) of a cover of a cable in the place, slightly pulling a cover.
4. For adjustment of a cable of control of the delitelny gate install the gate in position of DEF (1). Fix an earring of a cable and a collar (2) covers of a cable.

Check

PERFORMANCE ORDER
1. Check the conditioner switch. When pressing the switch button (inclusion) contacts 5 and 6, and also 1 and 3 have to be closed накоротко.
2. Check serviceability of the switch of speed of rotation of the fan (see rice. Scheme of check of short circuit of contacts of the switch of speed of rotation of the fan). If contacts of the switch do not become isolated according to the enclosed scheme, then replace the control panel assembled.