Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
   4.1. Specifications
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Fan and relay of turning on of the fan
   4.5. Radiator and broad tank
   4.6. Pump of cooling liquid
   4.7. Sensor of temperature of cooling liquid
   4.8. Fan block
   4.9. Heater radiator
   + 4.10. Control panel of a heater and conditioner
   4.11. Vlagootodelitel of the conditioner
   4.12. Compressor
   4.13. Condenser
   4.14. Evaporator and broad valve
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



bbeb4949

4.5. Radiator and broad tank

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Merge liquid in a vessel (see subsection 2.8.4).
3. Disconnect the top and lower hoses of a radiator.
4. Disconnect a tank hose from a jellied mouth of a radiator.
5. Remove the fan.
6. On the cars equipped with automatic transmission disconnect from a radiator of the union of tubes of a supply of liquid to a transmission cooler. Substitute the pallet for collecting the spilled liquid, muffle the union.
7. Remove two top arms of fastening of a radiator.

Prevention

In the lower part the radiator is established on two probes on which rubber plugs are dressed. Probes densely come into body openings.


8. Remove a radiator, having lifted it up. Do not lose at the same time rubber plugs which have to be on the place before installation of a radiator. Be careful of the spilled liquid and sharp edges of a radiator.
9. Check existence of leaks from a radiator, mechanical damages, purity of internal channels. In need of repair address in a specialized workshop, or to service of car service of the dealer as use of the special equipment and technologies will be necessary.
10. Remove insects and dirt from intercostal radiator spaces, having blown it compressed air and having cleared a soft brush. When cleaning do not bend radiator fins.
11. The radiator upside-down is established. Be convinced available rubber plugs on assembly probes of a radiator.
12. After installation of a radiator fill the cooling system with liquid with the necessary ratio of water and antifreeze.
13. Start the engine and watch formation of leaks from all broken demountable connections. Warm up the engine up to the working temperature, being guided on heating of both hoses of a radiator. Again check the level of cooling liquid, if necessary restore.
14. On the cars equipped with automatic transmission check the level of transmission liquid, if necessary restore.

Broad tank

PERFORMANCE ORDER
1. On the majority of cars the tank simply gets from the arm close to the battery. Take aside a tee from a tank (it is specified by an arrow) and remove a tank from an arm (the right arrow).
2. Merge in a vessel liquid from a tank, examine a tank, check existence on it of cracks and pomyatost. At detection of signs of damages replace a tank.
3. The tank is established upside-down.