Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
- 11. Body
11.1. Maintenance and repair
11.2. Vinyl finishing
11.3. Upholstery and rugs
11.4. Repair of insignificant damages of a body
11.5. Repair of considerable damages of a body
11.6. Loops and locks
11.7. Windshield and motionless glasses
11.8. Cowl
11.9. Trunk lid
11:10. A back door (models with a body "Station wagon")
11:11. Basic rack of a back door
11:12. Decorative panel of a door
11:13. Door
11:14. Door latch, cylinder of the lock and handle
11:15. Door windowpane
11:16. Bumpers
11:17. External mirror
11:18. Seats
11:19. Frame of a combination of devices
11:20. Glove compartment
11:21. Central decorative panel
11:22. Casing of a steering column
11:23. Lower panel of finishing of a steering column
11:24. Console
11:25. Dashboard
11:26. Front grille
11:27. Ventilating grate of a cowl
11:28. Seat belts
+ 12. Electric equipment
|
Prevention
The cowl weighs quite a lot therefore it is difficult to remove and establish it. Holding these procedures requires, at least, two persons.
Removal and installation
| PERFORMANCE ORDER |
|
1. Make marks around heads of bolts to provide the correct combination in installation time. |
| 2. Use fabric to cover a body and wings in the field of a cowl. It will allow to protect a body and paint during removal of a cowl. |
| 3. Disconnect any wires or ropes which can interfere with removal. |
| 4. Let your assistant supports a cowl. Unscrew bolts of fastening of loops to a cowl. |
| 5. Remove a cowl. |
| 6. Installation is carried out in the return sequence. |
|
Adjustment
| PERFORMANCE ORDER |
| 1. Longitudinal and cross adjustment of a cowl is carried out by loop wing shift after weakening of bolts. |
| 2. Put the line around all wing of a loop that you could judge extent of movement. |
| 3. Weaken bolts or nuts and shift a cowl to achieve exact combination. Every time shift a cowl on small distance. Tighten bolts of a loop and carefully lower a cowl to check its placement. |
|
4. If it is necessary, after installation it is possible to adjust all lock of a cowl, both down, and across on a radiator support so that the cowl was closed densely, level with wings. To carry out adjustment, put the line around adjusting bolts of the lock of a cowl to have a reference point, and then weaken bolts and displace the lock as it is necessary. Tighten adjusting bolts. |
|
5. In conclusion adjust cowl shock-absorbers on a radiator support so that the cowl was in a closed position level with wings. |
| 6. The cowl lock, also as well as loops, it is necessary to grease periodically with white lithium jellied lubricant to prevent jamming and wear. |
|
|
|
