Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
- 11. Body
   11.1. Maintenance and repair
   11.2. Vinyl finishing
   11.3. Upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Windshield and motionless glasses
   11.8. Cowl
   11.9. Trunk lid
   11:10. A back door (models with a body "Station wagon")
   11:11. Basic rack of a back door
   11:12. Decorative panel of a door
   11:13. Door
   11:14. Door latch, cylinder of the lock and handle
   11:15. Door windowpane
   11:16. Bumpers
   11:17. External mirror
   11:18. Seats
   11:19. Frame of a combination of devices
   11:20. Glove compartment
   11:21. Central decorative panel
   11:22. Casing of a steering column
   11:23. Lower panel of finishing of a steering column
   11:24. Console
   11:25. Dashboard
   11:26. Front grille
   11:27. Ventilating grate of a cowl
   11:28. Seat belts
+ 12. Electric equipment

11:12. Decorative panel of a door

Removal

PERFORMANCE ORDER

1. Disconnect a wire of "weight" from the accumulator. Prevention If the speaker system in your car is equipped with anticreeping system, be convinced that you know the correct activation code before disconnecting the accumulator.

2. On the models equipped with glasses with the manual drive remove the handle of a window regulator, feats back and forth fabric behind the handle until the clamp (it is specified by an arrow) does not move forward so that it could be removed. For holding this procedure there is special adaptation, however, it is possible to do also without it.
	4. Having unfastened a clamp, pull out the handle. On the models equipped with the electric drive of a window regulator take switch knot, disconnect the electric socket and remove it.
5. Remove a decorative covering of an external mirror (see subsection 11.17).
6. Remove the internal handle of a door (see subsection 11.14).
	7. By means of the screw-driver raise an armrest.
	8. Unscrew fixing screws of decorative finishing of a door and remove an armrest.
9. Insert the wide pallet, the thin screw-driver or the special device for removal of decorative finishing of a door between finishing and a door to disconnect fixing clips. Do this operation on all outer edge to unfasten the panel.
	10. When all clips are disconnected, unfasten decorative finishing of a door, disconnect all electric connections and remove the decorative panel from the car, having carefully pulled it up.
	11. To get access to an inside door, remove the plastic guard protecting a door from moisture hit. Remove a plastic covering, trying not to tear it. Remove the plastic condensing rings if it is necessary.

Installation

PERFORMANCE ORDER

1. To install the decorative panel, first of all, establish into place the guard warning a door from moisture hit. If it is necessary, add more sealant to fix it on the place.

2. Before installation of the panel of a door be convinced that all clips in the panel which could jump out during removal or remain at doors, are established.

3. Connect all electric connections and place the panel into place. Pressure her to fix clips, and establish all fixing screws and the door handle / armrest. Install the handle of a manual window regulator or the switch of an electrowindow regulator.

home