Toyota Corolla

1992-1998 of release

Repair and operation of the car


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
- 11. Body
   11.1. Maintenance and repair
   11.2. Vinyl finishing
   11.3. Upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Windshield and motionless glasses
   11.8. Cowl
   11.9. Trunk lid
   11:10. A back door (models with a body "Station wagon")
   11:11. Basic rack of a back door
   11:12. Decorative panel of a door
   11:13. Door
   11:14. Door latch, cylinder of the lock and handle
   11:15. Door windowpane
   11:16. Bumpers
   11:17. External mirror
   11:18. Seats
   11:19. Frame of a combination of devices
   11:20. Glove compartment
   11:21. Central decorative panel
   11:22. Casing of a steering column
   11:23. Lower panel of finishing of a steering column
   11:24. Console
   11:25. Dashboard
   11:26. Front grille
   11:27. Ventilating grate of a cowl
   11:28. Seat belts
+ 12. Electric equipment



bbeb4949

11:10. A back door (models with a body "Station wagon")
GENERAL INFORMATION
Prevention

The back door weighs quite a lot therefore it is difficult to remove and establish it. Holding these procedures requires, at least, two persons.

Removal
PERFORMANCE ORDER
1. Open a back door and close edges of a luggage carrier rags to protect the painted surfaces from damages during removal of a back door.
2. Disconnect any ropes or sockets of wires which can interfere with removal.
3. Use a marker to make marks around fixing flanges of a loop before unscrewing bolts.
4. Let your assistant supports a back door. Disconnect basic racks (see subsection 11.11).
5. By means of the assistant supporting a back door unscrew bolts of fastening of a back door to loops on both sides and remove a back door.

Installation and adjustment
PERFORMANCE ORDER
1. Installation is carried out in the return sequence.
Prevention

In installation time of a back door combine loops with the marks made during removal.
2. After installation close a back door and be convinced that it is located correctly rather surrounding panels.
3. Adjustment of an arrangement of a back door is made by weakening of bolts or nuts of fastening of a back door to loops and small movement of a back door.
4. The arrangement of the lock of a back door can be adjusted, having weakened adjusting bolts and having moved the lock. The latch of the lock can be adjusted, having weakened fixing bolts and having slightly knocked on it with the plastic hammer.