Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
- 8. Coupling and half shafts
   8.1. Specifications
   - 8.2. Coupling
      8.2.1. Coupling elements
      8.2.2. Release bearing and fork of switching off of coupling
      8.2.3. Main cylinder of the drive of switching off of coupling
      8.2.4. Working cylinder of the drive of switching off of coupling
      8.2.5. Hydraulic system of the drive of switching off of coupling
      8.2.6. The switch blocking start of the engine
   + 8.3. Half shaft
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



bbeb4949

8.2.6. The switch blocking start of the engine

Check

PERFORMANCE ORDER
1. Check height of installation of a pedal of coupling, its free wheeling and a free wheeling of a pusher (see subsection 8.2).
2. Check that the engine could not be started when the pedal of coupling is released. Check that the engine was started if to squeeze out a coupling pedal up to the end.
3. If the switch does not work as it is described, adjust it, or if it is necessary, replace.
4. The switch blocking start of the engine (1) is located under the dashboard on an arm before a coupling pedal. Find it and disconnect the connection socket.
5. By means of an ohmmeter check that the switch carried current when it is included, it should not carry current when it is switched off (the pedal of coupling is squeezed out).

6. Check that the switch did not carry current when it is switched off (the pedal of coupling is released).
7. If the switch is faulty, replace it.

Replacement

PERFORMANCE ORDER
1. Turn off a nut, the next to a switch plunger, and unscrew the switch. Disconnect the connection socket.
2. Installation is carried out upside-down removals. The switch is self-regulating therefore it is not necessary to adjust it.
3. Again check that the engine was not started if the pedal of coupling is not squeezed out up to the end, and it was started if it is squeezed out.