Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
- 7.1. Mechanical transmission
7.1.1. Specifications
7.1.2. The switching ropes
7.1.3. Gear shifting lever
7.1.4. Switch of headlights of a backing
7.1.5. Removal and installation of the transmission
7.1.6. Transmission partition
+ 7.2. Automatic transmission
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Check
| PERFORMANCE ORDER |
| 1. The switch of headlights of a backing is located from above transmissions. |
| 2. Turn a key in the ignition lock in situation On and include transfer of a backing. The switch has to close a chain and headlights of a backing have to light up. |
| 3. If headlights do not light up, check a safety lock of headlights of a backing (see subsection 12.1). |
| 4. If a safety lock as it should be, check that at the switch there was tension (at the included ignition). |
| 5. If tension is absent, check connecting wires between a safety lock and the switch; if tension is present, include transfer of a backing and check whether the switch closed a chain. |
| 6. If the switch does not close a chain, replace it; if the switch as it should be, check, one of backing headlights burns at least. |
| 7. If only one headlight burns, replace a bulb of other headlight; if both headlights do not burn, it is possible that bulbs of both headlights fused, but nevertheless it is more probable that the wire is broken off or there is a bad connection somewhere between the switch and headlights. |
|
Replacement
| PERFORMANCE ORDER |
|
1. Disconnect the connection socket from the switch of headlights of a backing (it is specified by an arrow). |
| 2. Unscrew the old switch. |
| 3. For check of the new switch before installation, check its work, having connected an ohmmeter to its plugs: at the pressed plunger it has to carry current; if releases a plunger, the switch should not carry current. |
| 4. Install the new switch into place and reliably twirl it. |
| 5. Connect the connection socket. |
| 6. Check operation of the switch. |
|
|
|
