Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Petrol engines
      - 3.1.1. Repair work without dismantle of the engine from the car
         3.1.1.1. Specifications
         3.1.1.2. Installation of the piston of the 1st cylinder in MW of a step of compression
         3.1.1.3. Cover of a head of the block of cylinders
         3.1.1.4. The soaking-up collector
         3.1.1.5. Final collector
         3.1.1.6. Gear belt
         3.1.1.7. Forward epiploon of the crankshaft
         3.1.1.8. Cam-shaft epiploon
         3.1.1.9. Cam-shafts and pushers (engines of 1,3 l)
         3.1.1.10. Cam-shafts and pushers (l engines 1,6 and 1,8)
         3.1.1.11. Head of the block of cylinders
         3.1.1.12. Oil pallet
         3.1.1.13. Oil pump
         3.1.1.14. Flywheel (or drive plate of the hydrotransformer)
         3.1.1.15. Back epiploon of the crankshaft
         3.1.1.16. Engine mount details
      + 3.1.2. Dismantle and capital repairs
   + 3.2. Diesel engine
   + 3.3. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

3.1.1.7. Forward epiploon of the crankshaft

Replacement

PERFORMANCE ORDER

1. Take off a gear belt and the leading gear wheel of the crankshaft (see subsection 3.1.1.6).
	2. Determine epiploon press fitting depth, then get an epiploon from the case of the oil pump, having hooked it the screw-driver or other tool. At extraction of an epiploon do not damage an opening under an epiploon or the surface of a neck of the crankshaft (at damage of the crankshaft the new epiploon will leak).
	3. The epiploon which was in the use can be taken also in more reliable way for what make an incision a sharp knife a working edge of an epiploon in the specified place.
4. Clear an opening under an epiploon in the case of the oil pump and slightly oil an external surface of a new epiploon for the engine or universal lubricant. Grease working edges of an epiploon with lubricant on the basis of a molybdenum disulfide.
	5. Carefully press a new epiploon into place by means of a mandrel with a diameter a little smaller what diameter of an epiploon, and internal guide of a mandrel, or big face head.
6. Make sure that the epiploon evenly came into an opening on the same depth on which it was established before dismantling. In the absence of a mandrel it is possible to use a piece of a pipe of big diameter. After installation be convinced that the provision of a spring of an epiploon is not violated.
7. Establish a gear wheel of the crankshaft and a gear belt (see subsection 3.1.1.6).
8. Start the engine and be convinced of lack of a leak of a forward epiploon.

home