Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
+ 7.1. Mechanical transmission
- 7.2. Automatic transmission
7.2.1. Specifications
7.2.2. Diagnostics
7.2.3. Replacement of epiploons
7.2.4. Rope of a butterfly valve
7.2.5. The switching rope
7.2.6. The switch blocking inclusion of a starter by the included transfer
7.2.7. Fastening of the transmission
7.2.8. Removal and installation of the transmission
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment
|
Oil leak often happens because of wear of epiploons of axes and / or wear of an epiploon and sealing rings of the drive of a speedometer. Replacement of these epiploons is rather simple as it can be carried out, without removing the transmission from the car.
Epiploons of half shafts
Epiploons of half shafts are located on each side transmissions where vents of the internal ends of half shafts enter vents of gear wheels of differential. If you suspect that the epiploon of a half shaft proceeds, lift the car and establish it on support. If the epiploon proceeds, you will see an oil strip sideways of the transmission, under an epiploon.
| PERFORMANCE ORDER |
| 1. Remove a half shaft (cm. subsection 8.3). |
|
|
2. By means of the screw-driver accurately get an epiploon from a transmission nest. Try not to damage a nest of installation of an epiploon, otherwise the new epiploon will proceed. |
| 3. If the epiploon cannot be removed by means of the screw-driver, it is necessary to use the special tool for removal of epiploons (it is possible to get on a car market or in autoshop). |
|
4. Using the tool for installation of epiploons or a piece of a pipe of big diameter as a mandrel, establish a new epiploon. Accurately establish it in a nest and check that it was densely and it is up to the end established. |
| 5. On the A132L transmission completely established epiploon has to be flush with a transmission case surface; on the A240L model completely established epiploon of the left half shaft has to be 5,16 mm lower than a case surface, and an epiploon of the right half shaft – on 3,175 mm. |
| 6. Grease edges of a new epiploon with multi-purpose grease, and then establish a half shaft (cm. subsection 8.3). Try not to scratch edges of a new epiploon. |
|
Sealing ring of the sensor of speed
The sensor of speed is located on a transmission case.
| PERFORMANCE ORDER |
| 1. Examine area around the sensor on existence of potek of oil to define whether the sealing ring proceeds. |
|
|
2. Disconnect the socket of connection of the sensor of speed (it is specified by an arrow), turn off a bolt (it is specified by an arrow) and pull out the sensor from the transmission. |
| |
3. By means of the small screw-driver remove a sealing ring from the sensor and establish a new sealing ring. Try not to scratch the surface of the sensor or a flute of a sealing ring. Grease a new sealing ring with liquid of the automatic transmission for its protection at installation of the sensor. |
| 4. Installation is carried out upside-down removals. |
|
|
|
