Toyota Corolla

1992-1998 of release

Repair and operation of the car



Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmissions
   + 7.1. Mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Specifications
      7.2.2. Diagnostics
      7.2.3. Replacement of epiploons
      7.2.4. Rope of a butterfly valve
      7.2.5. The switching rope
      7.2.6. The switch blocking inclusion of a starter by the included transfer
      7.2.7. Fastening of the transmission
      7.2.8. Removal and installation of the transmission
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



bbeb4949

7.2.5. The switching rope

Removal and installation

PERFORMANCE ORDER
1. Disconnect a rope from the switching lever on the transmission, for this purpose turn off a nut (a photo at the left). Then remove the switching rope from the arm located on a forward part of the transmission for this purpose remove a clip (a photo on the right).
2. Remove the central console.
3. Turn off fixing screws of the display panel of the lever of gear shifting (are specified by shooters a photo at the left), lift the panel and get a lighting bulb (a photo on the right). Tie the panel to the gear shifting lever so that it did not disturb you during the work.
4. Get to the check (a photo at the left) and disconnect a rope from the gear shifting lever (a photo on the right).

5. Remove a fixing clip from a first line of the basis of the lever of gear shifting.
6. Stretch a rope via the plug in a body partition.
7. Installation is carried out upside-down removals.
8. After completion of installation adjust a rope.

Adjustment

PERFORMANCE ORDER
1. Turn off a nut on the lever of switching of the transmission.
2. Take away the lever to the right against the stop, then return back it on two divisions to the provision of neutral transfer.
3. Transfer the gear shifting lever in the car to the provision of neutral transfer.
4. Having a little pressed on the lever towards transfer of a backing, reliably put the clamp.
5. Check operation of the transmission, having switched the gear shifting lever through all provisions (try to start the engine by various transfers – the starter has to join only by the included parking or neutral transfer).