Toyota Corolla

1992-1998 of release

Repair and operation of the car

Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
- 6. System of decrease in toxicity
   6.1. Specifications
   6.2. Electronic control system
   6.3. Electronic control unit
   + 6.4. System of onboard diagnostics
   + 6.5. Sensors of system of automatic control of the engine
   6.6. System of catching of vapors of gasoline
   6.7. System of recirculation (EGR system)
   6.8. System of compulsory ventilation of a case (PCV system)
   6.9. Catalytic converter
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment

6.7. System of recirculation (EGR system)

GENERAL INFORMATION

Device of system of recirculation

1. Recirculation valve
2. Vacuum distributor
3. Channel R

4. Channel E
5. Electropneumatic valve
6. to (1) – (4)

1. Channel R
2. Channel E
3. Vacuum distributor
4. Electropneumatic valve
5. Control unit
6. From a final collector
7. Recirculation valve

Scheme of work of standard system of recirculation

Part 1

Recirculation of exhaust gases	Recirculation of gases is absent	Recirculation of gases is absent	Recirculation of gases is absent
Condition of the valve of recirculation	It is closed	It is closed	It is closed
Condition of the vacuum distributor	–	–	–
Pressure in the camera of the valve of recirculation	–	–	–
Provision of a butterfly valve	–	–	Cuts both channels from the inlet highway (below channel E)
Condition of the electropneumatic valve	It is switched off	It is included
Rotation speed	–	It is lower than 4000 rpm
Temperature	It is below 47 °C	It is above 53 °C

Part 2

Recirculation of exhaust gases	Recirculation of gases is absent	Recirculates	Recirculates (an admission of exhaust gases)	Recirculation of gases is absent
Condition of the valve of recirculation	It is closed	It is open	It is open	It is closed
Condition of the vacuum distributor	Opens the channel connecting to the atmosphere	Closes the channel connecting to the atmosphere	Closes the channel connecting to the atmosphere	–
Pressure in the camera of the valve of recirculation	* Pressure constantly changes from low to raised		**	–
Pressure in the camera of the valve of recirculation	(1) Low	(2) High	(3) High	–
Provision of a butterfly valve	Connects channel E to the inlet highway (between channels E and R)		Connects both channels to the inlet highway (above channel R)	–
Condition of the electropneumatic valve	It is included			(4) It is switched off
Rotation speed	It is lower than 4000 rpm			It is higher than 4000 rpm
Temperature	It is above 53 °C

** When the butterfly valve connects both channels of the distributor to the inlet highway, the last due to the created depression opens the recirculation valve, providing an admission of exhaust gases even with a low pressure of an exhaust.

*** The vacuum distributor is switched on when the work of speed of rotation of the engine on the indication of the sensor of depression exceeds some preset value.

**** If conclusions of TE1 and E1 of the socket of data transmission peremykatsya, then the vacuum distributor turns on.

For decrease in content of oxides of nitrogen decrease in temperature of combustion due to redirection of a part of these gases via the recirculation valve is provided in the soaking-up collector.

This system is installed on the cars sold in those regions in which rigid norms affect environmental pollution with exhaust gases.

The system of recirculation consists of the valve of recirculation, the vacuum distributor, the electropneumatic valve, an electronic control unit and the sensor of temperature.

RECIRCULATION VALVE

Check

PERFORMANCE ORDER

1. Start the engine and leave to idle.
2. Disconnect a vacuum hose from the valve of recirculation and on its place connect the portable vacuum pump.
	3. Create depression on the recirculation valve. Depression has to be steady, and the engine has to begin to work with interruptions.
4. If depression is unstable and the engine works, continues to work trouble-free, then replace the valve of recirculation.
5. If the vacuum gage shows steady depression, but the engine works trouble-free, then remove the valve of recirculation and check purity of the valve and the soaking-up collector. If necessary clear or replace the specified details.

FILTER OF THE VACUUM DISTRIBUTOR

Check

PERFORMANCE ORDER

1. Remove the vacuum distributor.

2. Uncover and check a condition of filters.

3. Clear or replace filters, establish into place a cover and the vacuum distributor.

SYSTEM OF RECIRCULATION

Check

PERFORMANCE ORDER

	1. Disconnect a hose from the valve of recirculation and connect the vacuum distributor to the recirculation valve through a tee with the vacuum gage.
	2. Start the engine and connect conclusions of TE1 and E1 of the diagnostic socket.
3. Until the engine got warm (temperature below 45 °C) be convinced that at a speed of rotation of 2500 rpm of the indication of the vacuum gage are absent. On the warm engine at a speed of rotation of 2500 rpm the vacuum gage has to show low depression. On completely heated-up engine at increase in speed of rotation up to 2500 rpm the vacuum gage has to show low depression also.
4. Check the electropneumatic valve. The electropneumatic valve is mounted on the soaking-up collector.
	5. Check the electropneumatic valve resistance which has to be ranging from 37 to 44 Ohms.
6. At unsatisfactory results of check replace the electropneumatic valve.

RECIRCULATION VALVE

Replacement of details of system

PERFORMANCE ORDER

1. Disconnect the battery from weight.
2. Remove the case of the air filter.
3. Disconnect from the camera of a butterfly valve a drive cable (see subsection 5.12).
4. Remove the camera of a butterfly valve from the soaking-up collector (see subsection 5.12).
5. Remove the vacuum distributor (see below).
6. Pick up the recirculation phone.
	7. Turn off bolts of fastening of the valve of recirculation and remove the valve.
8. The valve of recirculation is installed upside-down.

VACUUM DISTRIBUTOR OF SYSTEM OF RECIRCULATION

Replacement

PERFORMANCE ORDER

1. Disconnect vacuum hoses, previously having marked them, and get the vacuum distributor from an arm.

2. The vacuum distributor is installed upside-down.

home