Toyota Corolla

1992-1998 of release

Repair and operation of the car


Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
- 5. Fuel, exhaust systems
   5.1. Specifications
   5.2. Order of performance of a decompression of fuel system
   5.3. Fuel pump and pressure of fuel
   5.4. Removal and installation of the fuel pump
   5.5. Fuel level sensor
   5.6. Fuel pipes and joints
   5.7. Fuel tank
   5.8. Cleaning and repair of the fuel tank
   5.9. Air filter
   5.10. Cable of the drive of a butterfly valve
   5.11. System of electronic injection of fuel (EFI - system)
   5.12. Check and replacement of EFI units - systems
   5.13. Service of the exhaust system
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Suspension bracket and steering
+ 11. Body
+ 12. Electric equipment



bbeb4949

5.13. Service of the exhaust system
GENERAL INFORMATION

Details of the exhaust system

1, 3, 4. Laying
2. Forward section
5. Arm
6. Catalytic converter
7. Average section
 8, 9, 10, 11. Heat-insulating guard
12. Ring
13. Arm
14. Terminal section
Prevention

Survey and repair of the exhaust system is carried out only after full cooling of details of system.

The exhaust system consists of a final collector, catalytic converter, mufflers (average and terminal), the connecting pipes and details of their suspension bracket (arms, collars, pillows). The exhaust system fastens to a body through arms and rubber pillows. At failure of any of system details operation of the engine is followed by the increased noise.

For maintenance of the exhaust system in good repair periodically check a condition of details. Check existence of the dispersed seams, traces of a burn-out and decumulation by corrosion, and also other defects which are the reason of hit of exhaust gases in salon. The failed details are not subject to repair, they should be changed.

If details of system do not give in to removal because of a holding strap owing to corrosion, then they should be removed with cutting. Usually this procedure is performed in workshops by means of autogenous cutting. However, at desire to save on the cost of these works and in the absence of own gas-welding equipment, cutting can be executed a hacksaw. In the presence of compressed air cutting can be executed pneumatic scissors. At work put on glasses for protection of eyes against sawdust and a mitten.

At repair of the exhaust system follow the following rules:

      – remove details of the exhaust system one after another, since terminal section and finishing forward section;
      – to facilitate an otvorachivaniye of nuts and bolts grease them with the getting liquid;
      – when replacing pipes and mufflers surely replace details;
      – at assembly grease all carvings with the fixing structure;
      – between the bottom of a body and exhaust pipes there has to be a gap to prevent an overheat of a floor and destruction of an anticorrosive covering and a rug. Pay special attention at assembly to installation of catalytic converter and a heat-insulating guard.
Prevention

Catalytic converter works at very high temperature, its cooling requires a long time. Before removal of converter wait for its full cooling. Otherwise serious burns are possible.