Toyota Corolla
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel, exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Suspension bracket and steering
10.1. Specifications
10.2. Rack of a suspension bracket (lobby)
10.3. Suspension bracket rack
10.4. Stabilizer of cross stability (forward suspension bracket) and plug
10.5. Suspension bracket lever
10.6. Spherical hinges
10.7. Rotary fist and nave
10.8. Nave and hug bearing (forward wheel)
10.9. Stabilizer of cross stability (back suspension bracket) and plug
10:10. Rack of a suspension bracket (back)
10:11. Longitudinal draft
10:12. Cross drafts of a suspension bracket
10:13. Nave and bearing (back wheel)
10:14. Arm of a nave of a back wheel
10:15. Steering
10:16. Steering wheel
10:17. Tips of steering drafts
10:18. Steering transfer
10:19. Pump of system of strengthening of steering
10:20. System of strengthening of steering
10:21. Wheels and tires
10:22. Adjustment of angles of installation of wheels
+ 11. Body
+ 12. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Turn off nuts of fastening of a wheel, lift the car and establish it on support. Remove a wheel. |
|
2. Turn off and remove a fastening bolt (are specified by shooters) longitudinal thirst for a nave arm. |
|
3. Turn off and remove a fastening bolt (are specified by shooters) longitudinal thirst for an arm of a body and remove longitudinal draft from the car. |
|
Installation
| PERFORMANCE ORDER |
| Installation is carried out upside-down removals. Do not tighten bolts until the suspension bracket is lifted by means of a jack in that situation in which it is when the car costs on wheels. Tighten nuts till the required moment of an inhaling specified in the section of technical characteristics at the beginning of this chapter. Tighten nuts of fastening of the wheel until an inhaling specified in the section of technical characteristics in the corresponding chapter. |
|
|
|
